Magic Music Visuals

Greetings..!
when i map 2 buttons on my KORGNano Kontroler2 for 'prev entry' and 'next entry' it seems to work BUT when i hit the buttons it jumps forward or backwards 2 scenes (instead of one)..?!?!?! i've tried a few different buttons in case that's the problem but to no avain..at the moment i need to have a duplicate of each scene next to each other..
any ideas..(sorry if the question's been asked before but a search of the forums drew a blank)

cheers..!

What MIDI command does your controller button use?

Eric wrote:What MIDI command does your controller button use?

I'm not 100% sure what you mean (i just hit 'learn' and the button i want ) following is what i got from : nanoKONTROL2_MIDIimp. online for the 2 buttons i tried to learn/teach. (file attached if that's of use)


+--------+-------------------------- -+--------------------------------------------+
| Transport Button Prev Track parameters |
+--------+----------------------------+--------------------------------------------+
| 252 | Assign type | 0~2=No Assign/Control Change/Note |
| +----------------------------+--------------------------------------------+
| 253 | Button Behavior | 0/1=Momentary/Toggle |
| +----------------------------+--------------------------------------------+
| 254 | CC/Note Number | 0~127 |
| +----------------------------+--------------------------------------------+
| 255 | Off value | 0~127 |
| +----------------------------+--------------------------------------------+
| 256 | On value | 0~127 |
| +----------------------------+ -------------------------------------------+
| 257 | Reserved | 0 |
+--------+----------------------------+--------------------------------------------+
|258~263 | Next Track parameters | (Same as the Transport Prev Track format ) |
+--------+----------------------------+--------------------------------------------+

thanks for that..

Sorry I meant when you use MIDI Learn, what does it say is the detected command?

For example:

I had this issue with the NanoK2.

The only commands I had issues with were the playlist too.
I was using the Nano2's Marker Arrow Keys < >
I think it is tripping on both on and off commands.

I solved it by going into Korg Controller and swapping the Note channels to Control channels.
Also, set them to Toggle, or you will have to hit the button Twice to move once. (The opposite of the 2 skip it is doing now)

Left arrow is switched to CC Toggle (works)... Right arrow (Original setting) Note (does the 2 skip in playlist)... I'm not sure if these were the default settings or if I changed them,
but either way- the korg controller software can help!

thanks for that folks..i'll give that a try,,,