Align "waveform" module to zero crossing
Posted: Wed Nov 07, 2018 11:35 am
Hey there,
would be cool if it was possible to enable waveform alignment to the wave's zero crossing.
In the youtube example below you can see what I mean. The sawtooth waves in the top two lanes align to the left hand of the oscilloscope whenever the wave crosses the zero from minus to plus; giving a pretty neat effect (starting 1:18):
Compare with the same tune done in Magic, the sawtooth wanders freely and wildly, depending on its frequency (starting 1:20)
Would love if you'd consider it, those "oscilloscope" videos of chip music are quite popular.
Kind regards
Markus
would be cool if it was possible to enable waveform alignment to the wave's zero crossing.
In the youtube example below you can see what I mean. The sawtooth waves in the top two lanes align to the left hand of the oscilloscope whenever the wave crosses the zero from minus to plus; giving a pretty neat effect (starting 1:18):
Compare with the same tune done in Magic, the sawtooth wanders freely and wildly, depending on its frequency (starting 1:20)
Would love if you'd consider it, those "oscilloscope" videos of chip music are quite popular.
Kind regards
Markus