Hi guys, do you have any tips to fix the serrated edge?
Edge blur problem
-
- Posts: 710
- Joined: Sun Sep 14, 2014 8:15 am
- Location: UK
- Contact:
Re: Edge blur problem
The serrations are known as "aliasing".
At the expense of some of your blur, you can add an Antialias module between the Edge Blur module and the Magic Module.
At the expense of some of your blur, you can add an Antialias module between the Edge Blur module and the Magic Module.
Re: Edge blur problem
Thank you Terry Payman, I wasn't sure it was aliasing.
I have already tried antialias but it acts invasively on the images contained in it. If there is no other solution, I think it may be necessary to correct the code in the Edge blur module.
I have already tried antialias but it acts invasively on the images contained in it. If there is no other solution, I think it may be necessary to correct the code in the Edge blur module.
Re: Edge blur problem
No need to update the code. There's almost always a workaround. A lot of ISF's and modules will alias, it's just a fact of life when balancing visual quality over realtime performance. Having said that, sometimes the workarounds are computationally expensive.
It will potentially impact framerate, but you can use a resolution module to render at a higher resolution, effectively oversampling, which will antialias at your final output resolution. It's a good technique to have in your toolbox.
You can also use a combination of two Resolution modules. e.g. If your final output is 1920x1080, do this:
SOURCE > EDGE BLUR > [RESOLUTION @ 3840x2160] > [RESOLUTION @ 1920x1080].
The first Res module oversamples everything to the left of it in the chain, and the second Res module scales it all back down again to the target resolution and anti-aliases it.
It will potentially impact framerate, but you can use a resolution module to render at a higher resolution, effectively oversampling, which will antialias at your final output resolution. It's a good technique to have in your toolbox.
You can also use a combination of two Resolution modules. e.g. If your final output is 1920x1080, do this:
SOURCE > EDGE BLUR > [RESOLUTION @ 3840x2160] > [RESOLUTION @ 1920x1080].
The first Res module oversamples everything to the left of it in the chain, and the second Res module scales it all back down again to the target resolution and anti-aliases it.
Re: Edge blur problem
Thanks artnik is a good idea even if it negatively affects the frames but if for now it is the only choice, better this than nothing