Hey MMV Forums,
Quick question:
I've been experimenting with sine oscillation a bit and I'm wanting to wrap it a small level.
I want the oscillator to start at 0 and move only between 0 and 0.1. If I give it a small oscillation, it moves slowly but it still needs to travel all the way up to 1 before it starts reversing. What would be a good way to cap this oscillation at 0.1?
Hope everyone enjoys their weekend.
Using sine-waves
Re: Using sine-waves
Set your scale to 0.1 before the OSC
Re: Using sine-waves
Thank you perzon! What if want it to move between 0.5 and 0.6 ? I would offset (add) 0.5 before the scale ?perzon wrote:Set your scale to 0.1 before the OSC
-
- Posts: 57
- Joined: Fri Aug 25, 2017 12:26 am
Re: Using sine-waves
Hey perzon,
You are correct. here is what I used that seemed to work for me:
sine oscillator 0.1
scale 0.1
offset + .5 (put this on either a specific parameter or global parameter)
You are correct. here is what I used that seemed to work for me:
sine oscillator 0.1
scale 0.1
offset + .5 (put this on either a specific parameter or global parameter)