Is it possible to setup a time delayed effect with expressions? What I am trying to accomplish is have an effect module be delayed until a certain point in the current scene.
Thanks
Seth
How do I do a time based effect?
Re: How do I do a time based effect?
without knowing exactly what you're trying to do, one simple idea to delay an effect is the use of a input switch like so...
note that i used an increase modifier and then clamped it...for the increase modifier, the value represent a speed of which 1.0 = 1 second... so, in my example, 0.5 would represent 2 seconds...
the input switch connector on the left starts at 0, so when the modifier value is less than one, it will pass through what ever is connected to Input 0 thru...when the modifier value reaches 1, it will only pass through whatever is connected to Input 1...
also bear in mind that, for this to work as expected when the scene is called up from the playlist, that synchronize modules on reselect must be active... this will ensure that the ramp value will be reset to Zero when the scene is engaged by the playlist either through auto-advance or you clicking on the playlist scene button....
anyway, hope this example can give you a starting/inspiration point to go from...
note that i used an increase modifier and then clamped it...for the increase modifier, the value represent a speed of which 1.0 = 1 second... so, in my example, 0.5 would represent 2 seconds...
the input switch connector on the left starts at 0, so when the modifier value is less than one, it will pass through what ever is connected to Input 0 thru...when the modifier value reaches 1, it will only pass through whatever is connected to Input 1...
also bear in mind that, for this to work as expected when the scene is called up from the playlist, that synchronize modules on reselect must be active... this will ensure that the ramp value will be reset to Zero when the scene is engaged by the playlist either through auto-advance or you clicking on the playlist scene button....
anyway, hope this example can give you a starting/inspiration point to go from...
Re: How do I do a time based effect?
here's a way to do it with an expression to control the bypass switch of an effect...
if you want it active for a period of time, you could enter an expression similar to this...
if((x>1 and x<10),1,0)
1= bypass on (tick on) 0 = bypass off (tick off)
if the increase is set to 0.5, then the effect would turn on after 2 seconds and stop at 20 seconds...
btw, i'm slowly learning how to use expressions myself
if you want it active for a period of time, you could enter an expression similar to this...
if((x>1 and x<10),1,0)
1= bypass on (tick on) 0 = bypass off (tick off)
if the increase is set to 0.5, then the effect would turn on after 2 seconds and stop at 20 seconds...
btw, i'm slowly learning how to use expressions myself